NuImage Awnings 70X5240494902C Bedienerhandbuch PDF herunterladen (Seite 10)

DETAIL #11

the Philips screws provided. (See Detail #10) Lift the hood into place and align the "T" bolts

with the slot in the hood brackets and secure with nuts. If the Weatherguard Cover needs to

be closer to the house, then the "T" bolts should be moved from the outer track to the center

track (See Detail #11)

DETAIL #10

2-5 Roof Mount Installation: (6000, 7000, 8000 series only)

When installing roof mount brackets, it is important that all brackets be level, and plumb to

the front of the facia. By mounting the brackets plumb to the facia, gear operation can be

utilized from the deck or patio with the use of the hand crank. A proper sealant must be used

around all lag bolts through roofing to prevent any possibility of leaking. Ask your retailer for

their recommendation of sealant. The following instructions assume the installation is on a

pitched roof with standard roof shingles and wood frame construction. For all other types

seek the assistance of a local building contractor.

Tools needed for installation:

A. Drill E. Level

" Drill Bit F. Step Ladder

" Drill Bit G. Caulking Gun

D. Adjustable Wrench

First, measure the entire length of the

awning. Determine the position (left

or right) on the roof where the awning

is to be located and mark both ends

with an "E" for end. Locate all the roof

rafters between the two "E's" and mark

the edge of the roofing with an "R"

over each rafter. (See Detail #12)

Measure the distance from each end of

the awning to the center of the arm

supports, (See Detail #13) then

transfer this measurement in from

both "E" marks, and mark this

measurement "A" for arms.

DETAIL #12

p.9

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

NuImage Awnings 70X5240494902C Bedienerhandbuch Seite 10