NuImage Awnings 70X5240494902C Bedienerhandbuch Seite 4

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 20
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 3
support the weight of the awning when extended. It is critical that the mounting lag bolts
be installed into a stud or header board. Plywood sheathing or equivalent will not
support the awning. If the awning is to be mounted under the soffit (overhang), a
Weatherguard Cover is not necessary. However, if your awning is not protected we strongly
recommend the purchase of a Weatherguard Cover. See your local retailer where you
purchased this awning.
If you have chosen the roof mount option, please see the instructions in Sec. 2-5 Roof Mount
Installation at this time. You will return to Sec. 2-3 Awning Installation instructions later.
2-3 Awning Installation:
For wall mount installation, there are two options available. Choose the one that best fits your
desired application. For the best installation on any surface use option "A". If mounting over
stucco use option "A" only.
To achieve the proper amount of headroom under your awning, after the installation is
completed, we recommend securing the mounting brackets a minimum of 7'-6" above the
deck or patio. If you have ordered the optional WeatherGuard Cover (Sec. 2-4), see the
instructions for additional information and brackets required during the installation of
options "A" or "B".
Option "A" (See Detail #1) Measure the length of the awning. Determine the position (left
to right) on the wall where the awning is to be mounted, and mark each end with an "E" for
end. Locate all studs between the two "E's" and mark the siding with an "S" over each stud.
Install a 2" x 8" pressure treated header board on the wall at desired mounting height, the
entire length of the awning. Use a 2" x 10" if you have ordered the Weatherguard Cover
option. (Other dimensional materials such as spruce may be used for the header board, but
must be capped with aluminum, painted or stained for weather protection). The header board
can be mounted directly over wood lap siding with the use of siding blocks or shims available
DETAIL #1A
DETAIL #1B
p.3
Seitenansicht 3
1 2 3 4 5 6 7 8 9 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare