Retractable AwningOwners Manual6000 Series7000 Series8000 Series
DETAIL #11the Philips screws provided. (See Detail #10) Lift the hood into place and align the "T" boltswith the slot in the hood brackets a
DETAIL #13DETAIL #14p.10Locate the "R" mark closest to the "A" mark. With roof bracket Section "1" as a g
Attach remaining sections to Sec. "1" using the 3/8" x 31/2" hex bolts, washers, and nutsprovided. (See Detail #15) Do not c
2-6 Motors and Controls: (optional)If you purchased the optional motorized version, your Futureguard Retractable Awning hasbeen equipped with a state
3-2 Motorized Operation:Your new motorized retractable awning has been equipped and preset with factory limitswitches. These settings wil
4. CARE & MAINTENANCE4-1 Fabric Care & Cleaning:The fabric on your awning is made from 100% solution-dyed acrylic yarns. Solution dying isth
opposite end from the gear or motor).Using the silicone spray with a strawattached to the spray nozzle, lubricategenerously the area
4. Unable to adjust the pitch on the awning. (8000 Series only)SolutionThe awning is already at its maximum height or drop. Do not force the awning an
Limited Frame WarrantyAll Futureguard Awnings are covered by a limited warranty from the date of originalpurchase. This warranty covers Futureguard
Motor Limited WarrantyFutureguard warrants that its motors and electronics will be free from defects andperform to the standards applied in the
Futureguard Owner’s Installation & Operation ManualProducts Covered6000 Series7000 Series 8000 SeriesTABLE OF CONTENTS1. Introduction: Pages #1-1
Manufactured by Futureguard, Inc.Auburn, ME
1. INTRODUCTION1-1 Customer Service:Congratulations and thank you for purchasing a Futureguard Retractable Awning. We areconfident of your satisfact
support the weight of the awning when extended. It is critical that the mounting lag boltsbe installed into a stud or header board. Plywood s
DETAIL #1DETAIL #2p.4at your local retailer, however if your home has vinyl siding we recommend cutting andremoving the siding, and s
supports (shoulder). Mark this on the header board with an "A". (See Detail #3). Measureover a minimum of 3" to either side of this mar
INSTALLATION ON MASONRY:Tools needed for assembly:A. DrillB. 3/16" or 1/4" masonry drill bitC.5/8" masonry drill bitD.9/16" socket
Mounting the Awning:Once all the mounting brackets have been installed on the wall, it is time to place the awningin the brackets. This step will requ
1. Attach a Weatherguard Hood Bracket next to each wall bracket (See Detail #7)2. Slide the hood sections togetheras shown in (Detail #8). For
Kommentare zu diesen Handbüchern